PARTS
1. Chicken loop:
We provide two chicken loops, one for hooked riding with the dingy guy to avoid unhooking accidentally, another one for easy unhooking (freestyle and waves).
2. Quick release:
Our molded quick release is super simple to open and just as easy to reassemble. It’s light and small so you can almost forget it.
3. Handle pass leach + quick release:
The handle pass leash can be also be used as a front line leash. You can always release it by pushing away the little red tube.
4. Bar:
Our bar is made of 50%carbon-fibre and 50% fiberglass, which makes it really strong, even with its fairly small diameter. It will be perfect for beginners and expert riders alike who want a narrow bar for handle pass maneuvers. The bar length of 50 cm will fit all of our kites and make it really simple when you want to change the size of your kite. There is no need to change the bar. However, we produce three different colors, one for each rabbit, so you can always recognize which bar is for which kite. Also for pictures, even if you don t see the kite you’ll be able to know which size kite the rider is on…Smart no?
5 Center line rope:
The rope used for the center line is a 5mm Dynema rope with a PU tube to cover it and protect it. It will last very long.
6 Stopper ball:
The stopper ball is adjustable, if you don t like as much length on the centerline and want to reduce the de-power a bit, then you can open the screw, slide the ball down and re-tighten.
7 Clam cleat + magic Velcro:
For us, it’s the most accurate adjustment system, and also the easiest one. The Velcro will help you to keep the extra adjustment rope from flying around and bothering you.
8 Adjustment rope:
We provide two adjustment ropes. Made of 5 mm Dynema rope, it will last long, but as the clam cleat is sharp, it will be damaged after a while, that’s why you have to keep an eye on it and change it before it breaks.
9 Safety red balls + swivel:
In case of emergency, or if you just want to land your kite alone: you should grab the loop behind the red ball, and activate the QR. The front line will slide through the ring above the swivel, killing all the power of the kite. The swivel allows you to always keep your front lines from twisting, which allows the safety balls to work properly. Wash it before and after your kite session.
10 Re-launch balls:
The rabbit re-launches by pulling one of the back lines when the kite falls and the leading edge is on the water. The re-launch will be easier when you grab the re-launch ball and pull it towards you.
11 Floaters:
The Floaters cover the back lines, which is then covered by PVC tubing. This will provide durability for your lines, and reduce the risk of tangling back lines around the bar ends in re-launching situations.
12 Bar ends:
The end of the bar is smooth and low, providing a good feeling when stirring (not too easy, not too hard). It also gives you all the space needed to roll up your lines, and have a little benji inside to block them when they are rolled around the bar
